Ask questions and find answers on STM32 microprocessors and dedicated embedded software solutions, such as Yocto SDK, Qt, and OP-TEE.
I want to run OpenSTDroid on the STM32MP2 DK board, I cannot wait for ST to add support so what's the bare minimum I can do to run it on the DK board? I don't mind WiFi or Bluetooth not working, I just want to get Android running first, Then I can wo...
Hi,I am trying to use USART6 on STM32MP257F-DK development board. I have enabled it in the device tree, recompiled it and I now can see the /dev/ttySTM1 node. The problem is, that sometimes, after reboot, any access to the USART (even changing its ba...
Dear All,I would like to use MYD-LD25X development board, which uses the STM32MP257 I plan to run FreeRTOS on the M33 core and Linux on the A35 cores.Do you know if there are documents that I can follow to run FreeRTOS on M33 core and Linux on the A3...
1. Qt6 Multimedia (PySide6) – 1080p Video Playback RequirementOur application requires smooth video playback using Qt Multimedia with PySide6 at resolutions up to 1080p.I understand that Qt6 supports hardware acceleration for 3D graphics through the ...
Hello ST, We are trying to enable USART6 as a serial console, in the stm32mp257f-dk board, we have builded the SDK using Openstlinux "Distribution package", I had done the below changes in the stm32mp257f-dk.dts device tree present in the kernel...
I have observed that on the STM32MP25 series running OpenSTLinux, the GPU OpenVX packages are correctly built and the *.so files are present in the rootfs. However, after the do_image step, these libraries are removed and are missing in the resultin...
Dear All,I would like to use MYD-LD25X development board, which uses the STM32MP257I plan to run FreeRTOS on the M33 core and Linux on the A35 cores.Do you know if there are documents that I can follow to run FreeRTOS on M33 core and Linux on the A35...
Hi im working on stm32mp257f-ev1 and the "edt,etml0700z9ndha" display,Im unable to decode the logic why the back-light enable gpio only gets high when there is a display connected in the lvds port, what logic is used to detect the lvds display connec...
We have a custom stm32mp25 board. On Mickledore we were able to create a/b partitions in our machine conf doing the following: PARTITIONS_IMAGES += "tc-appfs-a tc-appfs-b" STM32MP_TCFS_IMAGE ?= "ti-tc-appfs" STM32MP_TCFS_LABEL_A ?= "tc-appfs-a" ST...
Hii, I am using STPMIC25A with STM32mp257FAK3 with DDR3L in one custom design and LPDDR4 in second custom design.I am able to change o/p of Buck 4, Buck 6 and LDO 3 as per the requirement by changing the voltage for the same in the device tree, under...
